I was hearing a lot of noise while driving my 2007 Honda Fit Sport, especially around 55-60 MPH. The sound could best be described as a WOM WOM WOM WOM that got louder as vehicle speed increased. This how-to DIY video shows the parts needed to remove and install the front wheel bearing, as well as all of the parts and tools needed to do this job at home in my garage. Oh, I live in northern Ohio, so everything was extremely rusty, making this job much more difficult than it normally would have been!
PARTS:
Wheel bearing OEM: https://www.hondapartsnow.com/genuine/honda~bearing~assy~44300-s9h-003.html
Front hub OEM: https://www.hondapartsnow.com/genuine/honda~hub~assy~44600-sln-a00.html
CHEAP Bearing + Hub set x 2: https://ebay.us/XRahYe
ABS sensor Driver Side https://amzn.to/3QGCs3E
ABS sensor Passenger Side https://amzn.to/47zdrxh
Beck Arnley 103-0504 axle nut: https://amzn.to/3CKhZnn
TOOLS:
Impact Driver https://amzn.to/45WMaTV (or drill)
small chisel
big hammer
needle nose pliers
slide hammer + 4x100mm adapter https://amzn.to/45WcmOO
FWD Bearing Puller Installer Kit (only works if you can pull the hub out with slide hammer) https://amzn.to/3QFiGFV
large snap ring pliers https://amzn.to/3FIwBVi
32mm axle nut socket https://amzn.to/46WC1If
3/8” ratchet
10mm socket
12mm socket
1/2” breaker bar
17mm socket
19mm socket
12mm wrench
19mm wrench
1 7/16 socket to press bearing
freezer
bucket
brake cleaner
anti-seize grease https://amzn.to/3Sq7gXQ
OPTIONAL:
Impact wrench (save a lot of time)
Dremel (to cut bearing race, if not replacing hubs)
IF YOUR FIT IS AS RUSTY AS MINE:
PB Blaster
12 ton press https://amzn.to/3Mr3eul
17mm universal socket (for lower ball joint nut) https://amzn.to/3SoUQzi
Drill (for broken ABS sensor)
24mm socket (to press hub from bearing) https://amzn.to/3sgKas6
punch (to tap snap ring)
Propane Torch